I hope you guys could help and shed light on this. My video is an anime video which is 160MB, but the output size is 10GB with the use of virtualdubmod. Download XviD4PSP 7.0.502 Windows 64-bit 26MB Win64 Download XviD4PSP 7.0.502 Windows 23MB Win Download XviD4PSP 7.0.502 Mac 21MB Mac Download Xvid4PSP 5.10. When I tried to do the job, the output size of the file is 100 times bigger than the that of the original file. My PC is only athlon 64 3000, which is a bit slower than any other PC out there nowadays. And besides, I don't even know how long it is going to take to reencode the whole video with the subs.
![xvid4psp make input and output bitrate the same xvid4psp make input and output bitrate the same](https://i.stack.imgur.com/1nDqb.png)
But the K-Lite Pack I installed already have the ffshow installed which contains the x264 codes there.
#XVID4PSP MAKE INPUT AND OUTPUT BITRATE THE SAME HOW TO#
A lot of people suggest using virtualdubmod to do the job, but I don't even know how to start, and when I went to check the compression, I didn't see the list of x264 or h264 there. I have installed the K-lite codec pack in FULL VERSION, that means I have all the codes I need for the job to be done. Even they are similar, but there are slight different in here or there so I make a post asking for help. Some are similar but without any solutions. I have read through all the threads that are related to my questions.
![xvid4psp make input and output bitrate the same xvid4psp make input and output bitrate the same](https://blog.scottlogic.com/ceberhardt/assets/ffmpeg-wasm-threads.png)
It works independently of versions 5/6/7/8.0. It does not depend on system codecs and any system components everything is inside. Set the next device to its lowest input sensitivity, normally 0dB or line level on the input (and ensure phantom power is disabled), then connect the EXPO output to the input of the next device. XviD4PSP NEW VERSION 8.1.36 / 7.0.502 XviD4PSP 8.1 is a program for convenient and high-quality video and audio conversion. However, the subtitle I get is the softsub one and now I wanna hardsub it with my avi video and how can I do that? To calibrate the analog output of the EXPO to the input of the next device send a 1kHz sine tone at 0dB RMS over CobraNet to the EXPO. Well.I was able to successfully turn the mkv video into an avi.